This role can be based in either Glenrothes or Livingston working a hybrid working pattern

Main Duties

* Working effectively within a multi-disciplined design team, adhering to company policies & procedures

* Analogue & Power Electronic product design

* Solving complex technical problems on new and existing products from our portfolio

* Electronic Schematic capture layout & simulation

* Design, commissioning, circuit debug and fault diagnosis through the project lifecycle

* Awareness and application of DFM&T (Design for Manufacture & Test)

* Document Verification and Qualification of products to industry and customer standards

* Configuration of product designs and their controlled change.

* Prepare technical document & reports

* Support internal & customer discussions, leading in your area of expertise.

Essential Experience:

* Prior exposure and experience within Power Electronics/Design

* Good and demonstrable problem-solving skills with practical laboratory test, circuit & test measurement experience

* Good communicator able to engage technically within the company and to customers

Desirable

* Experience with interfacing to RF circuitry and high-speed D/A/A/D conversion

* Experience with both RF and Power development

* Experience with programmable devices

* Experience in design of Switch Mode Power supplies, designs of Invertor and PFC design of full bridge, flyback, forward topologies or exposure to others

* Experience using the Mentor Graphics tool suite; xDX Designer, Constraints Editor, HyperLynx tools such as Signal Integrity & Power Analyser, System Vision simulation or equivalents would be advantageous.

* Knowledge of Firmware development, design and test using suitable toolsets (i.e. Xilinx Vivado, ModelSim). Proven analytical skills in circuit simulation (Matlab, LT Spice)

* Awareness and application of DFM&T (Design for Manufacture & Test)

* Experience of recognised standards MIL Std, IPS etc